VI-24
2.4 Paper Discharger Unit Replacement
<Criterion of Replacement>
The paper discharger should be replaced with a new discharger unit at the same
time as the Transfer roller according to the periodical maintenance cycle set out in
Table 6-4.
When time is due for replacement of paper discharger unit, the following message
appears on the control panel.
LJ READY 001P T1
REPLACE 120K KIT
<Purpose of Replacement
To prevent the discharging efficiency from declining due to deterioration of the paper
discharger unit.
PRECAUTION
Do not touch the corona wire of the paper discharger unit.
<Necessary Tools and Replacement Materials>
1) Two or three pieces of cotton cloth for cleaning
2) Paper discharger (one unit)
<Work Procedures>
Sequence of Disassembling
1) After turning off the printer, unplug the power cable from the power outlet.
2) Open the rear access cover. (Fig.6-
21)
Fig.6-21
Rear Access Cove
To Next Page
Loading...
