Brother HL-2400C - Drum Cleaner Replacement

VI-26
2.5 Drum Cleaner Replacement
<Criterion of Replacement>
The drum cleaner should be replaced with a new one according to the periodical
maintenance cycle set out in Table 6-4.
When time is due for replacement of the drum cleaner, the following message
appears on the control panel.
LJ READY 001P T1
REPLACE 120K KIT
<Purpose of Replacement
To prevent the cleaning efficiency from declining due to deterioration of the drum
cleaner.
PRECAUTION
When installing the drum cleaner, firstly locate the bearing and the bias pole into the
contacts. Reconfirm this connection prior to testing the printer.
<Necessary Tools and Replacement Materials>
1) Two or three pieces of cotton cloth for cleaning.
2) Drum cleaner (one unit)
<Work Procedure>
Sequence of Disassembling
1) Turn off the printer.
2) Open the top cover.
Sequence of Replacement
1) Remove the cleaner cover by
releasing the two hooks.(Fig.6-24)
Fig.6-24
Cleaner Cover
Top Cover
Hook