Brother HL-2400C - IOD2 PCB (with Base)

VII-10
Fig.7-10
4.1.6 IOD2 PCB (with base)
1) Disconnect all the harness connectors (13 pcs.) connected to the IOD2 PCB.
2) Remove the set screws ST3X6 (2 pcs.) from the IOD2 PCB base.
3) Remove the IOD2 PCB (with base) from the main body.
PRECAUTION
When handling the IOD2 PCB take care not to cause electrostatic damage to the PCB.
Fig.7-11
C ring
C rin
g
C rin
g
Registration clutch
Fuser clutch
Cleaner clutch
IOD2 PCB