Brother HL-2400C - High Voltage Unit

VII-27
4.3.2 High Voltage Unit
1) Remove the Main (Video Controller) PCB guide rail (upper).
Fig.7-42
2) Remove the set screws ST3X6 (5 pcs.) from shield case ‘A’ assembly.
3) Remove the fan duct from the power supply.
Fig.7-43
4) Disconnect all the harnesses (5 pcs.) connected to the high voltage unit.
5) Remove the set screws ST3X6 (1 pc.) and BT3X8 (6 pcs.) from the high voltage
power supply unit.
6) Remove the high voltage power supply unit.
Main PCB guide
rail (upper)
Shield case ‘A’
Fan duct