Brother HL-2400C - Rear of the Printer; Rear Access Cover (L); Transfer Unit

VII-40
4.6 Rear of the Printer
4.6.1 Rear Access Cover (L) / Transfer Unit
1) Open the rear access cover.
2) Remove the upper screw of the retaining strap supporting the transfer unit to the
printer body.
3) Remove the set screw ST3X6 (1 pc.) from the left hand side transfer unit metal
retaining plate.
4) Remove the metal retaining plate.
5) Remove the support shaft from the installation hole at the right hand side while lifting
the unit slightly.
Fig.7-67
6) Remove the transfer unit with the rear access cover.
7) Remove the set screws ST3X8 (4 pcs.) from the transfer unit.
8) Remove the transfer unit from the rear access cover.
Fig.7-68
Note:
When reassembling the transfer unit, install the support shaft into the right hand hole first.
Metal retaining
plate
Retaining strap
Rear Access
Cover(L)
Transfer Unit
Support shaft

