VIII-3
2. OPERATOR CALL
2.1 Video Controller Mode
The Ready LED is lit and an applicable message appears on the liquid crystal display
(LCD) in the following cases;
1) Consumables require to be replenished.
2) Waste toner pack is full of waste toner.
3) Paper jam.
4) Periodic maintenance.
5) Maintenance work incomplete.
The above cases are not regarded as a breakdown, and should be treated in accordance
with Table 8-1;
Table 8-1
Display Message Meaning Countermeasure
CHECK XX TRAY
No paper in the media
cassette (XX is
TRAY1 / TRAY2)
Check the adjustment lever
at the bottom of the upper
media cassette and adjust to
the correct setting when the
CHECK TRAY1 message
appears.
Load a stack of paper into the
cassette.
12 COVER OPEN FRONT
The front cover is
open
Close the front cover.
12 COVER OPEN TOP
The top cover is open. Close the top cover.
12 COVER OPEN REAR
The rear access cover
is open.
Close the rear access cover.
13 JAM XXXXXX
Paper jam in the
printer. XXXXXX is
DRUM / FEEDER /
INSIDE / REAR.
Remove the jammed paper
from the indicated area.
14 NO CARTRIDGE
XXXX COLOR
No toner cartridge in
the printer.
Install the requested toner
cartridge.
XX NO CASSETTE
No media cassette.
XX is T1 / T2.
Install the requested media
cassette.
16 TONER EMPTY XXXX
COLOR
Toner almost empty:
Another 50 pages
may be printed. (The
Alarm LED is lit at the
same time.)
Remove the toner cartridge,
rock it several times by 45
°
,
and install it again or replace
the toner cartridge with a new
one.
XX LOAD PAPER *****
SIZE
Incorrect size of paper
in the media cassette
XX. XX is T1 / T2.
(The message
appears alternately to
show a particular
size.)
Load the requested size of
paper in the media cassette
and press the Form Feed
button.
To Next Page
Loading...
