A-17
8. TO INSTALL THE PRINTER CORRECTLY
Please read the installation steps described below carefully.
If the printer is not installed correctly, image failures may occur or the life expectancy of
the OPC belt cartridge may be shortened.
1) Turn ON the power switch of the printer.
2) After the printer has initialized, open the front cover and then the top cover of the
printer and pull up the OPC belt cartridge from the printer.
3) Measure the gap on the OPC belt cartridge shown in the figure below. If the gap is
in the range of 5 ± 2 mm, the printer is installed correctly.
PR99010
OPC Belt Cartridge
5 ± 2 mm
To Next Page
Loading...
