1-30
☛
4.
Place the envelopes in the multi-purpose tray so they touch the back of the
tray and remain below the limit
▼
mark.
Fig. 1-19
✒ Note
Make sure that the neatly stacked paper is correctly seated on the multi-
purpose tray, otherwise paper may not be fed correctly, resulting in a skewed
printout or a paper jam
☛
5.
Press and slide the paper width adjuster to fit the envelope size.
Fig. 1-20
✒ Note
When you place paper on the multi-purpose tray, note the following:
• The print surface must be face up.
• The leading edge must be placed inside first so it rests lightly against
the printer.
• The top of the paper stack must be under the guides that are on both
sides of the tray.
Up to
▼
mark.
To Next Page
Loading...
