HL-2460 SERVICE MANUAL
4-36
(7) Release the hook and pull out the paper feed roller ASSY MP in the direction of the arrow
as shown in the figure blow.
(8) Unhook the hook to remove the gear 44 at the right hand side from the MP tray frame.
Unhook the hook to remove the plate cam gear 28. Then remove the paper feed idle gear
28 and plate cam MPR.
(9) Unhook the hooks to remove the bearing R and L from the MP feed roller shaft MP and
remove the MP feed roller shaft MP from the MP tray frame.
Fig. 4-63
NOTE:
After replacing the paper feed roller ASSY MP, be sure to close the roller cover MP completely.
NOTE:
When re-assembling gears, follow the direction below:
(1) Fit the cam gear 44 to the MP tray frame, then turn it counterclockwise until it stops.
(2) Fit the plate cam MPR to the MP tray frame.
(3) Fit the paper feed idle gear 28 to the MP tray frame aligning notches of the paper feed idle
gear 28 to the plate cam MPR and the cam gear 44.
(4) Fit the plate cam gear 28 and the gear 44, and then MP gear 15 to the MP tray frame.
Fig. 4-63a
Bearing R
Bearing L
MP feed roller shaft MP
Hook
Gear 44
Plate cam gear 28
Paper feed
idle gear 28
Plate cam MPR
MP tray frame
Paper feed roller ASSY MP
PR2001076
Plate cam gear 28
Gear 44
Plate cam MPR
Plate feed idle gear 28
Cam gear 44
MP gear 15
MP tray frame
To Next Page
Loading...
