Brother HL-2460 - 6. NETWORK BOARD OPERATION; 6.1 Installing the Network Board

CHAPTER 2 INSTALLATION AND BASIC OPERATION
2-46
6. NETWORK BOARD OPERATION (HL-2460N AND OPTION FOR HL-2460)
Installing the network board enables you to use the printer in the TCP/IP, IPX/SPX, AppleTalk,
DLC/LLC, Banyan VINES, DEC LAT and NetBEUI environments. Also, useful utilities such as
BR-Admin32 and network printing software for the administrator are included. For more
information about set up, see section 3. ‘INSTALL THE PRINTER’ in this chapter.
6.1 Installing the Network Board
(1) Turn off the printer power, and then unplug
the power cord. Disconnect the interface
cable (printer cable) from the printer.
(2) Open the side cover.
Fig. 2-1
(3) Unscrew the three screws in the order shown,
and then remove the metal plate.
Fig. 2-2
(4) Unscrew the two screws, and then remove
the network cover plate.
Fig. 2-3
1
2
3