Brother HL-4000CN - Actuator Full; Sensor Photo: Full Stack

IV-18
2.2.2 Actuator full
1) While pulling the center of the actuator full shaft upwards, pull the right hand end of
the shaft forwards to clear the sensor and release the right end of the shaft.
2) Move the shaft to the right to release the left end of the shaft and remove it.
Fig.4-26
2.2.3 Sensor photo: full stack
1) Remove the connector on the sensor photo: full stack.
2) Release the 3 hooks securing the sensor photo: full stack to the chute ASSY out.
3) Remove the sensor photo: full stack from the chute ASSY out.
Fig.4-27
Actuator full
Sensor photo: full stack
1
2
3