Brother HL-4000CN - Latch R; Sensor TNR Full

IV-30
2.2.20 Sensor TNR full
1) Release the 2 hooks securing the sensor TNR full to the front ASSY in.
2) Remove the connector on the sensor TNR full.
3) Remove the sensor TNR full from the front ASSY in.
Fig.4-46
2.2.21 Latch R
1) Release the hook at the lower part of the spring latch securing it to the hole on the
right side of the front ASSY in.
2) Release the hook securing the latch R to the front ASSY in.
3) Pull out the latch R from the front ASSY in together with the shaft latch and the spring
latch.
4) Remove the spring latch from the latch R.
5) Pull out the shaft latch from the latch R.
Fig.4-47
Sensor TNR full
Front
Front ASSY in
Shaft latch
Latch R
Spring latch