Brother HL-4000CN - Actuator I;R

IV-51
2.4.5 Drive ASSY DEVE
1) Remove 5 screws securing the Drive ASSY DEVE from the right side of the printer.
2) Remove the Drive ASSY DEVE from the printer.
Fig.4-85
2.4.6 Actuator I/R
1) From the right side of the printer, release the hook of the spring I/R from the convex
portion of the plate ASSY lever R.
2) Release the hook securing the actuator I/R to the shaft on the plate ASSY lever R.
3) Remove the actuator I/R from the plate ASSY lever R together with the spring I/R.
4) Remove the spring I/R from the actuator I/R.
Fig.4-86
Drive ASSY DEVE
Actuator I/R
Screw, DT M4x10
Screw, DT M4x10