Confidential
3-117
8.59 Charge HVPS PCB ASSY
(1) Remove the cup S M3x6 Taptite screw and two bind B M4x12 Taptite screws, and then
release the four Hooks to remove the Charge HVPS PCB ASSY from the Frame unit.
Fig. 3-173
(2) Disconnect the eight connectors and flat cable from the Charge HVPS PCB ASSY.
Note:
When disconnecting the connectors, they may be damaged if pulling the Charge HVPS
PCB ASSY by force.
CN1
CN3
CN9
CN5
CN6 CN7
CN2
CN8
CN4
Fig. 3-174
Hooks
Charge HVPS PCB ASSY
Taptite, bind B M4x12
Taptite, cup S M3x6
Taptite, bind B M4x12
Positioning pin
Hook
Charge HVPS PCB ASSY
Frame unit
<Right side>
To Next Page
Loading...
