Control panel setup
105
10
Printing the Printer Settings Page 10
Note
Node name: Node name appears in the Printer Settings Page. The default Node name of the network card
in the printer is “BRNxxxxxx” for a wired network and "BRWxxxxxx" for a wireless network (where
“xxxxxx” is the last six digits of the Ethernet address).
The Printer Settings Page prints a report listing all the current printer settings including the network print
server settings. You can print the Printer Settings Page using the printer control panel.
How to print the Printer Settings Page 10
a Make sure that the front cover is closed and the power cord is plugged in.
b Turn on the printer and wait until the printer is in the Ready state.
c Press any of the Menu buttons (+, -, OK or Back) of the control panel on your printer to take the printer
offline.
d Press the + or - button to select Machine Info..
e Press OK, and then press OK again to print the Printer Settings Page.
Restoring the network settings to factory default 10
If you wish to reset the print server back to its default factory settings (resetting all information such as the
password and IP address information), please follow these steps:
a Make sure that the front cover is closed and the power cord is plugged in.
b Turn on the printer and wait until the printer is in the Ready state.
c Press any of the Menu buttons (+, -, OK or Back) of the control panel on your printer to take the printer
offline.
d Press the + or - button to choose LAN. Press OK.
e Press the + or - button to choose Factory Reset. Press OK.
f Press OK again.
Note
You can reset the print server back to its default factory settings using the BRAdmin application or Web
Based Management (web browser). For more information, see Changing the print server
settings on page 15.
To Next Page
Loading...
