Troubleshooting
137
13
Wireless network troubleshooting 13
Wireless setup problems 13
The Brother print server is not found during setup using the automatic installer application on the
CD-ROM.
13
a Make sure that the printer is powered on, is on-line and ready to print.
b Move your computer closer to the Brother printer and try again.
c Reset the print server back to its default factory settings and try again. For the information how to reset
to the factory default settings, see Restoring the network settings to factory default on page 105.
Why do I have to change my printer’s network setting to “Wired LAN” during setup although I am
trying to setup Wireless LAN?
13
If you are using Windows
®
2000, Mac OS
®
X 10.2.4 or greater or your computer is connected to the wireless
network using a network cable, it is recommended you temporarily connect the printer to your access point,
hub or router using a network cable. You will also need to change your printer’s network setting to wired LAN
temporarily. Your printer’s network setting will be changed to wireless LAN automatically or during the course
of the setup.
For Intel
®
Centrino™ users: 13
The Brother Wireless Wizard software will not be able to automatically reconfigure the Windows
®
wireless
settings of your PC. Please see the following steps for wireless network setting procedures.
For Windows
®
: 13
Configuration in Infrastructure mode on page 36
Configuration with an access point that supports SecureEasySetup™ on page 32
Configuration in Ad-hoc mode on page 47
For Macintosh
®
: 13
Configuration in Infrastructure mode on page 63
Configuration with an access point that supports SecureEasySetup™ on page 59
Configuration in Ad-hoc mode on page 73
To Next Page
Loading...
