Configuring your printer for a wireless network (For HL-4070CDW)
23
3
Configuring your printer for a wireless network 3
There are three methods to configure your wireless network printer; by using the automatic installer
application in the CD-ROM (recommended), using the SecureEasySetup™ software and the printer control
panel.
Using the SecureEasySetup™ software to configure your printer for a wireless
network 3
The SecureEasySetup™ software of Broadcom Corporation is an easy way to configure your Brother device
to your wireless network settings. By pushing a button on the wireless router or access point, you can
complete setup and secure the wireless network. Your router or access point must also support
SecureEasySetup™. See the user’s guide for your wireless LAN router or access point for instructions to
configure your printer for a wireless network.
Note
Routers or access points that support SecureEasySetup™ have the SecureEasySetup™ symbol as
shown below.
a Place the Brother printer close to your wireless router/access point. (Less than 5 m/16 feet.).
b Push the SecureEasySetup™ button on your wireless router or access point. See the user’s guide for
your wireless router or access point for instructions.
c Press any of the Menu buttons (+, -, OK or Back) of the control panel on your printer to take the printer
offline.
Ready
h
Select ab or OK
Machine Info.
d Press the + or - button to select LAN.
Select ab or OK
LAN
e Press OK to move to the next menu level.
LAN
Wired
To Next Page
Loading...
