Configuring your printer for a wireless network (For HL-4070CDW)
24
3
f Press the + or - button to select WLAN.
LAN
WLAN
g Press the + or - button to select Setup WLAN.
WLAN
Setup WLAN
h Press OK to move to select the next level.
Setup WLAN
Setup Wizard
i Press the + or - button to select SecureEasySetup.
Setup WLAN
SecureEasySetup
j Press OK.
If the following message appears, press OK again.
WLAN Enable?
On
Note
The message above only appears when the wireless setting is disable.
k The wireless network connection status using the SecureEasySetup™ software will be displayed;
Connecting WLAN, Connected or Connection NG.
Connecting WLAN is displayed when the print server is trying to make connections to your router or
access point. Wait till either Connected or Connection NG is displayed.
Connected is displayed when the print server is successfully connected to your router or access point.
You can now use your printer in a wireless network.
Connection NG is displayed when the print server has not successfully connected to your router or
access point. Try starting from a again. If the same message is displayed again, reset the print server
back to the default factory settings and try again.
To Next Page
Loading...
