Wireless configuration for Macintosh
®
using the Brother automatic installer application
67
5
h Connect the Brother wireless device to your access point using a network cable and click Next. Go to m.
i If you choose This computer has wireless capability., check I am using an access point in
infrastructure mode, and then click Next. Go to j.
If you are using a wired computer, choose This computer uses a network cable to connect to the
wireless network., you must configure the wireless settings from the control panel. Click Next and
follow the on-screen instructions to complete the setup. See Using the Setup Wizard from the control
panel on page 25.
To Next Page
Loading...
