Confidential
2-31
(5) Assemble the MP lift arm 2 with aligning it with the three Bosses provided on the Front
door unit ASSY.
Note:
When assembling the MP lift arm 2, make sure that the shaft of the MP roller holder ASSY
is put into the hole on the MP lift arm 2.
Fig. 2-56
(6) Assemble the MP feed frame cover onto the Front door unit ASSY.
(7) Close the Front door unit ASSY.
Fig. 2-57
(8) After replacing the MP paper feeding kit, reset the counter. (Refer to “2.3 Parts Life Reset
Function” in this chapter.)
Front door unit ASSY
Hole
<Front side>
MP lift arm 2
Shaft
(MP roller holder ASSY)
Bosses
Hooks
MP feed frame cover
Front door unit ASSY
<Front side>
Hook
Hook
MP feed frame cover
To Next Page
Loading...
