Brother HL-4050CDN - Page 177

Confidential
3-69
(3) Remove the Retaining ring E3 fixing the Wire support rope, and then release the Wire
support rope from the Shaft.
Note:
When removing the Retaining ring E3, be careful not to drop it into the machine.
Fig. 3-86
(4) Remove the Collar 3 from the Hinge shaft L, and then remove the Hinge shaft L from the
Hinge plate L.
Fig. 3-87
Shaft
Wire support rope
Retaining ring E3
Front door unit ASSY
Hinge shaft L
Front door unit ASSY
Collar 3
Frame unit
Frame unit
<Right side>
Hinge plate L
<Left side>