Brother HL-4050CDN - Page 178

Confidential
3-70
(5) Remove the Collar 3 from the Hinge shaft R, and then remove the Hinge shaft R from the
Hinge plate R.
(6) Remove the Front door unit ASSY from Frame unit.
Fig. 3-88
Assembling Note:
- When assembling the Wire rope onto the Shaft on the main body, be careful of the direction
of Wire rope referring to the figure below.
Fig. 3-89
Front door unit ASSY
Collar 3
Hinge shaft R
Frame unit
<Front side>
Retaining ring E3
Retaining ring E3
Shaft
Shaft
Wire rope Wire rope
Hinge plate R