Confidential
1-28
Error code 8E
Registration
Registration failed. Press Go and try again.
Auto color registration failure when implementing it from the control panel
Error code 8F
Registration
Registration failed. See Troubleshooting chapter in User’s Guide.
Sensor sensitivity adjustment failure when implementing auto color registration from the control
panel
Error code 9D
Registration
Registration failed. See Troubleshooting chapter in User’s Guide.
Incorrect sensor measurement value when implementing auto color registration from the control
panel
User Check
- Check if there is a scratch, dirt or the like on the belt unit. If there is, replace the belt unit with
a new one.
Step Cause
Remedy
1 Harness connection failure of
registration-mark sensor PCB
ASSY
Check the harness connection of the registration-
mark sensor PCB ASSY and reconnect it.
2 Registration-mark sensor
PCB failure
Replace the registration-mark sensor PCB ASSY.
3 Transfer HVPS PCB unit
failure
Replace the transfer HVPS PCB unit.
4 Engine PCB failure Replace the engine PCB ASSY.
To Next Page
Loading...
