Confidential
2-5
(2) Put the Fuser unit into the machine and fix it with the two pan (washer) B M4x14 Taptite
screws.
Fig. 2-5
Note:
When assembling the fuser unit, make sure that the two Harnesses are placed in the
groove and under the rib of the Plastic frame. If they are not, then correct them as shown
in the figure below.
Fig. 2-6
Fuser unit
<Back side>
Harness
Plastic frame
Harness
Taptite, pan (washer) B M4x14
(Tightening torque: 1.00 ±0.1 N m)
Taptite, pan (washer) B M4x14
(Tightening torque: 1.00 ±0.1 N m)
To Next Page
Loading...
