Brother HL-4050CDN - Page 85

Confidential
2-9
(5) Remove the cup S M3x8 Taptite screw and three cup B M4x12 Taptite screws.
(6) Release the three Hooks on the bottom and the two hooks on the back side, and then
remove the Side cover L ASSY.
Note:
When removing the Side cover L ASSY, pay attention to the Wire support rope.
Fig. 2-12
(7) Remove the two cup B M4x12 Taptite screws and two cup S M4x8 Taptite screws.
(8) Release the one Hook on the front side, two Hooks on the bottom and the two Hooks on
the back side, and then remove the Side cover R ASSY.
Note:
When removing the Side cover R ASSY, be careful not to damage section “A”.
Fig. 2-13
Hook
Taptite, cup B M4x12
Taptite, cup S M3x8
Taptite, cup B M4x12
Hooks
Hooks
Side cover L ASSY
<Left side>
Taptite, cup S M4x8
Hooks
Side cover R ASSY
“A”
Taptite, cup S M4x8
Taptite, cup B M4x12
Hooks
<Right side>
Wire support rope
8a
8b
Hook