Brother HL-4050CDN - Page 89

Confidential
2-13
(15) Remove the ten cup S M3x6 Taptite screws (9 pieces from the top and 1 piece from the
front side), and then remove the Scanner cover.
Fig. 2-20
(16) Disconnect the two flat cables (CN1, CN4) and connector (CN8) from the Laser unit.
Fig. 2-21
Scanner cover
Taptite, cup S M3x6
Taptite, cup S M3x6
Taptite, cup S M3x6
Taptite, cup S M3x6
Frame unit
<Front side>
Laser unit
<Front side>