Brother HL-4050CDN - Page 90

Confidential
2-14
(17) Remove the seven cup S M3x6 SR Taptite screws, and then remove the four Scanner
holders and Laser unit.
Fig. 2-22
<Installing Procedure>
(1) Assemble the Laser unit with the four Scanner holders and seven cup S M3x6 SR Taptite
screws.
Note:
When assembling the Laser unit and Scanner holder, refer to the figure below.
Fig. 2-23
Scanner holder
Taptite, cup S M3x6 SR
Laser unit
Scanner holder
Frame unit
Taptite, cup S M3x6 SR
Taptite, cup S M3x6 SR
Scanner holder
Scanner holder
Taptite, cup S M3x6 SR
<Front side>
Scanner holder
Taptite, cup S M3x6 SR
Laser unit
Scanner holder
Frame unit
Taptite, cup S M3x6 SR
Taptite, cup S M3x6 SR
Scanner holder
Scanner holder
Taptite, cup S M3x6 SR
<Front side>