Wireless configuration for Windows
®
using the Brother automatic installer application
47
4
j If you choose This computer has wireless capability., check I am using an access point in
infrastructure mode, and then click Next. Go to l.
If you are using a wired computer, choose This computer uses a network cable to connect to the
wireless network., you must configure the wireless settings from the control panel. Click Finish and see
Using the Setup Wizard from the control panel on page 28.
If you have already completed the wireless settings and chose to install the printer driver in step e, click
Next. Go to k .
k Check the box after you confirm that you have completed the wireless settings, and then click Next.
Go to Installing the printer driver on page 64.
To Next Page
Loading...
