Wireless configuration for Macintosh
®
using the Brother automatic installer application
89
5
Note
• If you want to setup more than WEP key1, click Advanced.
• If you do not know the Authentication or Encryption settings for network, contact your network
administrator.
p Enter a new SSID and choose the Authentication Method and Encryption Mode from the pull-downs
in each setting box. Then enter the Network key and click Next.
Note
If you do not know the Authentication or Encryption settings for network, contact your network
administrator.
q Click Next. The settings will be sent to your printer. The settings will remain unchanged if you click
Cancel.
Note
If you want to manually enter the IP address settings of your printer, click Change IP Address and enter
the necessary IP address settings for your network.
To Next Page
Loading...
