Loading paper
15
Printing on envelopes and thick paper
from the MP tray 2
Before loading, press the corners and sides
of the envelopes to make them as flat as
possible.
a Open the MP tray and lower it gently.
b Pull out the MP tray support and unfold
the flap (1).
c Lift up the support flap to prevent
envelopes or thick sheets of paper from
sliding off the face-down output tray. If
the support flap is closed you should
remove each envelope as soon as it
comes out of the machine.
d Put up to 3 envelopes or up to 25 sheets
of thick paper (163 g/m
2
) in the MP tray.
If you add more envelopes or paper it
may cause a jam. Make sure:
The top edge of the envelope is
positioned between the arrows (1).
The side to be printed on must be
face up.
To Next Page
Loading...
