Brother HL-4200CN - Housing ASSY Retard; Clutch Turn

- IV-41 -
2.3.29 Housing ASSY retard
1) Remove the connector of the clutch turn from on the PWBA HBN MCU.
2) Remove 3 screws securing the housing ASSY retard to the printer.
3) Remove the housing ASSY retard from the printer.
Fig.4-73
2.3.30 Clutch turn
1) Remove the E-ring securing the clutch turn to the shaft of the housing ASSY retard.
2) Remove the clutch turn from the shaft of the housing ASSY retard.
Fig.4-74
Housing ASSY retard
Clutch turn
Housing ASSY retard
Screw, M3x10
Screw, M3x10