Brother HL-4200CN - Roll ASSY Retard; Roll Turn

- IV-42 -
2.3.31 Roll turn
1) Remove the E-ring securing the roll turn to the housing ASSY retard.
2) Pull out the bush earth securing the left side of the roll turn from the housing ASSY
retard.
3) Pull out the bush securing the right side of the roll turn from the housing ASSY
retard.
4) Slide the roll turn from the housing ASSY retard rightward, and pull out the roll turn
left and upward.
Fig.4-75
2.3.32 Roll ASSY retard
1) Push back the rear edge of the holder ASSY retard from the housing ASSY retard,
and turn the holder ASSY retard to the rear.
2) Sliding the holder ASSY retard rightward, pull the left shaft of holder ASSY retard
out of the bush bore in the housing ASSY retard.
Fig.4-76
Roll turn
Bush
Bush earth
Housing ASSY retard
Holder ASSY retard