Brother HL-4200CN - Actuator I;R; Drive ASSY DEVE

- IV-59 -
2.5.6 Drive ASSY DEVE
1) Remove 4 screws securing the Drive ASSY DEVE from the right side of the printer.
2) Remove the Drive ASSY DEVE from the printer.
Fig.4-105
2.5.7 Actuator I/R
1) From the right side of the printer, release the hook of the spring I/R from the convex
portion of the plate ASSY lever R.
2) Release the hook securing the actuator I/R to the shaft on the plate ASSY lever R.
3) Remove the actuator I/R from the plate ASSY lever R together with the spring I/R.
4) Remove the spring I/R from the actuator I/R.
Fig.4-106
Drive ASSY DEVE
A
ctuato
r
I/R
Screw, DT M4x10
Screw, DT M4x10