2-91
Confidential
■ Paper jam at the MP tray (Error code 8C)
<User Check>
- Check if the paper is loaded into the MP tray correctly.
- Turn back the paper loaded in the MP tray or change the orientation of the paper by 180°.
- Adjust the paper guide corresponding to the paper size.
- Check if too much paper is loaded in the tray.
- Check if the thickness of the paper is 60 to 163 g/m
2
.
■ Paper jam around the belt unit (Error code 88, etc.)
<User Check>
- Check if the belt unit is properly installed.
Step Cause Remedy
1 Foreign object around MP tray Remove the foreign object.
2 MP paper feeding kit worn out Replace the MP paper feeding kit.
3 MP registration front sensor
failure
Check the sensor performance following
the procedure described in “Function code
32”. If any problem occurs, replace the
MP paper empty/registration front sensor
PCB ASSY.
4 Engine PCB failure Replace the engine PCB ASSY.
5 Main PCB failure Replace the main PCB ASSY.
Step Cause Remedy
1 Registration rear actuator
malfunction
Re-assemble the registration rear
actuator.
2 Paper eject actuator
malfunction
Re-assemble the paper eject actuator.
3 Harness connection failure of
paper eject sensor PCB ASSY
Check the harness connection of the
paper eject sensor PCB ASSY and
reconnect it.
4 Harness connection failure of
drum drive motor
Check the harness connection of the
drum drive motor and reconnect it.
5 Paper eject sensor PCB failure Replace the paper eject sensor PCB
ASSY.
6 Drum drive motor failure Replace the drum drive motor.
7 Rotation failure of the heat roller Replace the fuser unit.
8 Engine PCB failure Replace the engine PCB ASSY.
9 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
