Brother HL-4570CDW - Page 335

5-22
Confidential
<Operating procedure after adjustment inter-color position alignment (auto)
fails>
1) Press the or button to display ”MAINTENANCE 66” on the LCD in the initial
state of the maintenance mode. Then, press the OK button. “REGISTRATION” is
displayed on the LCD. Load A4-size paper on the tray.
2) Press the or button to display “PRINT CHART” on the LCD, and then press the
OK button.
3) Display “PRINTING” on the LCD, and print the inter-color position alignment
adjustment chart. After printing, “PRINT CHART” is displayed again.
4) Press the or button to display “OFFSET ADJUST” on the LCD, and then press
the OK button. “1. MAGENTA = 0” is displayed on the LCD.
5) With the printed inter-color position alignment adjustment chart, check the numeric
value where the color is the darkest among the pattern (Magenta Left). Press
the or button to display that numeric value, and then press the OK button.
6) Enter the numeric value of the patterns to and to in the same way.
7) When you enter the numeric value of the pattern (Yellow Right), “COMPLETED” is
displayed.
8) Press the Cancel button to return to the printer to the initial state of the maintenance
mode.
■ Adjustment of inter-color position alignment (manual)
<Operating procedure>
(1) Press the or button to display “MAINTENANCE 66” on the LCD in the initial state of
the maintenance mode. Then, press the OK button. “REGISTRATION” is displayed on
the LCD. Load A4-size paper on the tray.
(2) Press the or button to display “PRINT CHART” on the LCD, and then press the OK
button.
(3) Display “PRINTING” on the LCD, and print the inter-color position alignment adjustment
chart. After printing, “PRINT CHART” is displayed again.
(4) Press the or button to display “SET REGISTRATION” on the LCD, and then press
the OK button. “1. MAGENTA = 0” is displayed on the LCD.
(5) With the printed inter-color position alignment adjustment chart, check the numeric value
where the color is the darkest among the pattern (Magenta Left). Press
the or button to display that numeric value, and then press the OK button.
(6) Enter the numeric value of the patterns to in the same way.
(7) When you enter the numeric value of the pattern (Yellow Right), “COMPLETED” is
displayed.
(8) Press the Cancel button to return to the printer to the initial state of the maintenance
mode.
1
2 3 7 9
9
1
2 9
9