7-23
Confidential
(26) Remove the Connector (CN8) and two Flat cables from the Laser unit to remove the
Laser unit from the Base frame unit.
Fig. 7-39
(27) After replacing the Laser unit, reset the counter. (Refer to “2.3 Parts Life Reset Function”
in Chapter 5.)
Assembling Note:
When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cable are not at an angle.
Base frame unit
Laser unit
Connector
26a
26b
<Front>
Flat cable
Flat cable
26a
CN8
To Next Page
Loading...
