Appendix
180
A
When EAN 128 set A, set B or set C is selected with the parameter ‘t132’ or ‘T132’, ‘t133’ or ‘T133’ or ‘t134’
or ‘T134’
The same rules apply as for ‘t12’ or ‘T12’, ‘t13’ or ‘T13’, or ‘t14’ or ‘T14’.
Box drawing A
ESC i ... E (or e)
‘E’ or ‘e’ is a terminator.
Line block drawing A
ESC i ... V (or v)
‘V’ or ‘v’ is a terminator.
Expanded character data start A
n = ‘l’ or ‘L’
Data that follows ‘l’ or ‘L’ is read as expanded character data (or labeling data). Expanded character data must
end with the ‘ \ ’ code (5CH), which also ends this command.
Table of Code(EAN) 128 set C
A
Code(EAN) 128 set C describes an original command. The correspondence table is as follows.
To Next Page
Loading...
