Brother HL-5140 - 2. COLOR MODES

HL-5130/5140/5150D/5150DN Service Manual
4-39
(23) Disconnect the connector for the eject sensor harness from the thermistor relay PCB
ASSY.
(24) Release the eject sensor harness from the three hooks.
(25) Remove the bind B M3x10 Taptite screw, and then remove the eject sensor PCB ASSY.
(26) Remove the bind B M3x10 Taptite screw, and then remove the thermistor relay PCB
ASSY.
Fig. 4-68
(27) Remove the paper eject actuator and eject actuator spring.
Fig. 4-69
Taptite, bind B M3x10
Taptite, bind B M3x10
FU frame lower
Thermistor relay PCB ASSY
Eject sensor PCB ASSY
FU frame lower
Eject actuator spring
Paper eject actuator
(hook)
Hooks
Hook
Eject sensor harness
1
2
3