Setting Up the Machine
9
2 Install the drum unit and
toner cartridge assembly
Improper Setup
DO NOT connect the interface cable yet.
1 Press the front cover release button and open
the front cover (1).
2 Unpack the drum unit and toner cartridge
assembly.
3 Rock it from side to side several times to
distribute the toner evenly inside the assembly.
4 Put the drum unit and toner cartridge assembly
into the printer.
5 Close the front cover of the printer.
3 Load paper in the paper tray
1 Pull the paper tray completely out of the printer.
2 While pressing the blue paper-guide release
lever (1), slide the paper guides to fit the paper
size. Make sure that the guides are firmly in the
slots.
3 Fan the stack of paper well to avoid paper jams
and misfeeds.
4 Put paper in the paper tray. Make sure that the
paper is flat in the tray and below the maximum
paper mark (1).
5 Put the paper tray firmly back in the printer.
1
1
1
To Next Page
Loading...
