• If the product has been exposed to rain or water.
• If the product does not operate normally when the operating instructions are followed. Adjust
only those controls that are covered by the operating instructions. Incorrect adjustment of
other controls may result in damage and will often require extensive work by a qualified
technician to restore the product to normal operation.
• If the product has been dropped or the casing has been damaged.
• If the product exhibits a distinct change in performance, indicating a need for service.
MFC models only
1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It
indicates no endorsement of the product by Telecom, nor does it provide any sort of
warranty. Above all, it provides no assurance that any item will work correctly in all respects
with another item of Telepermitted equipment of a different make or model, nor does it imply
that any product is compatible with all of Telecom’s network services.
2. This equipment is not capable, under all operating conditions, of correct operation at the
higher speeds for which it is designed. Telecom will accept no responsibility should
difficulties arise in such circumstances.
3. This equipment does not fully meet Telecom's impedance requirements. Performance
limitations may occur when used in conjunction with some parts of the network. Telecom will
accept no responsibility should difficulties arise in such circumstances.
4. This equipment shall not be set up to make automatic calls to the Telecom ‘111’ Emergency
Service.
5. This unit will only work in conjunction with a tone signalling (DTMF) telephone, but some
telephones may not be compatible. Since noise or speech from the telephone can upset
dialling from this unit, errors may result if the devices are used together in other than quiet
conditions.
6. Where it is necessary to dial prefix digits, such as a Caller Display override code (“0196” or
“0197”), this unit will have to be used in conjunction with an associated tone signalling
(DTMF) telephone.
7. Note that some telephones are NOT compatible with this unit and dialling errors may result if
the two devices are used together in other than quiet conditions. The Telecom Faults Service
is NOT to be called should such problems arise. In such cases, it is recommended that the
prefix and wanted number are dialled manually.
8. If a charge for local calls is unacceptable, the ‘Dial’ button should NOT be used for local
calls. Only the seven-digits of the local number should be dialled from your telephone. DO
NOT dial the area code digit or the ‘0’ prefix.
9. This equipment may not provide for the effective hand-over of a call to another device
connected to the same line.
10. Some parameters required for compliance with Telecom’s Telepermit requirements are
dependent on the equipment (PC) associated with this device. The associated equipment
shall be set to operate within the following limits for compliance with Telecom’s
Specifications: (a) There shall be no more than 10 call attempts to the same number within
15
To Next Page
Loading...
Need help?
General
Weight and Dimensions
