Brother HL-L6400DW - Page 333

Level 1 Level 2 Description
Carbon Menu
The menu appears when printing two pages or more.
Copy2 Macro …
Copy8 Macro
(Available only for
certain models)
Select a macro for Copy2 to 8.
The menu appears when printing two pages or more.
[Network]
Level 1
Level 2 Level 3 Description
Wired LAN TCP/IP Boot Method
Choose the IP method that best suits your needs.
IP Address
Enter the IP address.
Subnet Mask
Enter the Subnet mask.
Gateway
Enter the Gateway address.
IP Boot
Tries
Specify the number of attempts the machine will try to obtain
an IP address when the Boot Method is set to any setting
except Static.
APIPA
Allocate the IP address from the link-local address range
automatically
1
.
IPv6
Enable or disable the IPv6 protocol.
Ethernet
- Choose the Ethernet link mode.
Wired Status
- Display the Ethernet link status.
MAC Address
- Display the MAC address of the machine.
Set to Default
- Restore wired network settings of your machine to the
factory settings.
Wired Enable
- Turn the wired interface on or off.
WLAN TCP/IP Boot Method
Choose the IP method that best suits your needs.
IP Address
Enter the IP address.
Subnet Mask
Enter the Subnet mask.
Gateway
Enter the Gateway address.
IP Boot
Tries
Specify the number of attempts the machine will try to obtain
an IP address when the Boot Method is set to any setting
except Static.
APIPA
Allocate the IP address from the link-local address range
automatically
1
.
IPv6
Enable or disable the IPv6 protocol.
Setup Wizard
- Configure the wireless network settings using the setup
wizard.
WLAN Assistant
- Configure your wireless network settings using the Brother
CD-ROM.
WPS
- Configure your wireless network settings using the one-
button push method.
WPS w/PIN Code
- Configure the wireless network settings using WPS with a
PIN code.
WLAN Status Status
Display the wireless Ethernet link status.
Signal
Display the signal condition.
Channel
Display the channel in use when Status is Active.
Speed
Display the connection speed when Status is Active.
328