Brother HL-L9200CDW - 9.6 Fuser Unit

3-28
Confidential
9.6 Fuser Unit
(1) Remove the two Taptite bind B M4x12 screws from the Fuser cover R.
(2) Release the two Hooks and remove the Fuser cover R from the Main body.
Fig. 3-16
(3) Disconnect the two Connectors (CN1 and CN2) from the Eject sensor PCB ASSY.
Fig. 3-17
Assembling Note:
* Center thermistor has a black and blue connectors (230V models only).
The black connector may be connected to the blue insertion port and vice versa.
Taptite bind B M4x12
Fuser cover R
Hook
Main body
<Back side>
Connector
CN1
CN2
Eject sensor
CN1
CN2
<Back side>
PCB ASSY
*
Connector
(Center thermistor
harness
*
)