Brother HL-L9200CDW - 1.3.29 Reset counters for parts (Function code 88); 1.3.30 Exit from the maintenance mode (Function code 99)

5-58
Confidential
1.3.29 Reset counters for parts (Function code 88)
<Function>
After replacing a fuser unit, PF kit 1, 2, MP, laser unit, or low-voltage power supply PCB unit,
perform this function to increase the replacement count by one and reset the count to clear the
“Replace ***” warning.
<Operating procedure>
The parts that can be selected are shown in the table below.
* Displayed only when two LT are installed.
1.3.30 Exit from the maintenance mode (Function code 99)
<Function>
This function is used to exit from the maintenance mode, restart the machine, and return to the
ready state. If the error related to the fuser unit occurs, the error is cleared.
<Operating procedure>
Model without touch panel Model with touch panel
(1) Press the or key to display
“MAINTENANCE 88” on the LCD in the
initial state of the maintenance mode.
Then, press the OK key. “Reset-Laser
Unit” is displayed on the LCD.
(2) Press the or key to display the
part of which counter you want to reset
and press the OK key.
(3) Then “*******OK?” is displayed on the
LCD. When you press the Go key, the
counter of the selected part is reset,
and the machine returns to step (2)
again. (******* represents the selected
part name.)
(4) Press the Cancel key to return the
machine to the initial state of the
maintenance mode.
(1) Press the 8 key twice in the initial state
of the maintenance mode. “Reset-Laser
Unit” is displayed on the LCD.
(2) Press the or key to display the
part of which counter you want to reset
and press the Mono key.
(3) Then “*******OK?” is displayed on the
LCD. When you press the Mono key,
the counter of the selected part is reset,
and the machine returns to step (2)
again. (******* represents the selected
part name.)
(4) Press the X key to return the machine
to the initial state of the maintenance
mode.
LCD Part name
Reset-Laser Unit Laser unit
Reset-Fuser Unit Fuser unit
Reset-PF Kit T1 PF kit 1
Reset-PF Kit T2 PF kit 2
Reset-PF Kit T3
*
PF kit 3
Reset-PF Kit MP PF kit MP
Reset-LVPS Low-voltage power supply PCB unit
Model without touch panel
Model with touch panel
(1) Press the or key to display
“MAINTENANCE 99” on the LCD in the
initial state of the maintenance mode.
Then, press the OK key. The machine
exits from the maintenance mode and
return to the ready state.
(1) Press the 9 key twice in the initial state
of the maintenance mode. The machine
exits from the maintenance mode and
return to the ready state.