5-23
Confidential
■ Switching Dither Pattern
<Function>
This function is to switch the dither pattern when printed letters and/or slanted lines are not
smooth, and thin lines are rough or uneven.
“*” is displayed at the end of the currently specified function in the LCD display.
<Operating procedure>
LCD Description
PS.DitherType=0 Dither Pattern 0 is selected.
(
A dither pattern which improves roughness of letters and slanted lines
)
(default)
PS.DitherType=1 Dither Pattern 1 is selected.
(A dither pattern which alleviates banding)
Model without touch panel
Model with touch panel
(1) Press the or key to display
“MAINTENANCE 45” on the LCD in the
initial state of the maintenance mode.
Then, press the OK key. “USBNo.” is
displayed on the LCD.
(2) Press the or key to display
“PS.DitherType” and then press the OK
or Go key.
(3) Press the or key to select
“PS.DitherType=0” or
“PS.DitherType=1”, and press the OK
or Go key.
(4) “Accepted” is displayed on the LCD,
and the machine returns to the initial
state of the maintenance mode.
(1) Press the 4 and 5 keys in this order in
the initial state of the maintenance
mode. “USBNo.” is displayed on the
LCD.
(2) Press the or key to display
“PS.DitherType” and then press the
Mono or SET key.
(3) Press the or key to select
“PS.DitherType=0” or
“PS.DitherType=1”, and press the
Mono or SET key.
(4) “Accepted” is displayed on the LCD,
and the machine returns to the initial
state of the maintenance mode.
To Next Page
Loading...
