5-26
Confidential
■ Adjusting left-end print start position on second side in duplex printing
<Function>
This function is to adjust the left-end print start position on the second side in the left and right
direction if it is displaced in duplex printing. The adjustable range is -100 to 750 (unit: 300 dpi)
(The minus direction means the left direction.)
<Operating procedure>
Model without touch panel Model with touch panel
(1) Press the or key to display
“MAINTENANCE 45” on the LCD in the
initial state of the maintenance mode.
Then, press the OK key. “USBNo.” is
displayed on the LCD.
(2) Press the or key to display
“DX.XAdjust” and then press the OK or
Go key. “DX.XAdjust=**” is displayed
on the LCD.
(3) To move the print start position to the
left, press the key and decrease the
value. To move the print start position to
the right, press the key and increase
the value.
(4) When the value is changed to the
adjustment value, press the OK or Go
key. “Accepted” is displayed on the
LCD, and the machine returns to the
initial state of the maintenance mode.
(1) Press the 4 and 5 keys in this order in
the initial state of the maintenance
mode. “USBNo.” is displayed on the
LCD.
(2) Press the or key to display
“DX.XAdjust” and then press the Mono
or SET key. “DX.XAdjust=**” is
displayed on the LCD.
(3) To move the print start position to the
left, press the key and decrease the
value. To move the print start position to
the right, press the key and increase
the value.
(4) When the value is changed to the
adjustment value, press the Mono or
SET key. “Accepted” is displayed on the
LCD, and the machine returns to the
initial state of the maintenance mode.
To Next Page
Loading...
