Brother HL-L9300CDW - Page 37

2-17
Confidential
8602 ---
8603 ---
8604 ---
8701 ---
8702 ---
8703 ---
8801 ---
8802 ---
8901 ---
8902 ---
8903 The back cover sensor detected
the open state when
2-sided printing is started.
(before the registration of
printing in the engine)
2-69
8904 The back cover sensor detected
the open state during 2-sided
printing. (after the registration of
printing in the engine)
2-69
8A01 The registration rear sensor
detected that the fed paper was
larger or smaller than the
specified size in 2-sided printing.
2-69
8A02 The registration rear sensor
detected that the length of the
paper is too long and it may hit
within the machine in 2-sided
printing.
2-69
8C00 ---
8D01 The registration rear sensor
detected that the paper loaded
in the paper tray was smaller
than the specified size.
2-70
8D02 The paper size which is not
supported by the output tray is
set for printing from the printer
driver.
2-70
8E01 ---
8E02 ---
8E03 ---
8F01 ---
8F02 ---
8F03 ---
Error
Codes
Description
Refer
to:
9001 The size of paper loaded in the
MP tray and the one specified
from the driver are not same
when paper is fed from the MP
tray.
2-71
9002 The size of paper loaded in the
paper tray 1 and the one
specified from the driver are not
same when paper is fed from the
paper tray 1.
2-71
9003 The size of paper loaded in the
T2 paper tray unit and the one
specified from the driver are not
same when paper is fed from the
T2 paper tray unit.
2-71
9004 The size of paper loaded in the
T3 paper tray unit and the one
specified from the driver are not
same when paper is fed from the
T3 paper tray unit.
2-71
9005 ---
9102 ---
9103 ---
9104 ---
9105 ---
9200 ---
9301 When paper was fed from the
MP tray, the MP paper empty
sensor detected that no paper
was in the MP tray.
2-72
9302 When paper was fed from the
paper tray 1, the T1 paper feed
sensor detected that no paper
was in the paper tray 1.
2-72
9303 When paper was fed from the T2
paper tray unit, the T2 paper
feed sensor detected that no
paper was in the T2 paper tray
unit.
2-73
9304 When paper was fed from the T3
paper tray unit, the T3 paper
feed sensor detected that no
paper was in the T3 paper tray
unit.
2-73
9305 ---
Error
Codes
Description
Refer
to: