2-70
Confidential
■ Error code 8D01
The registration rear sensor detected that the paper loaded in the paper tray was smaller than
the specified size.
< User Check >
- Open the back cover and print using the straight paper path.
- Length of the paper is 114 mm or more.
■ Error code 8D02
The paper size which is not supported by the output tray is set for printing from the printer driver.
< User Check >
- The size of paper actually loaded and the one specified from the driver shall be the one
within the specified range.
- Open the back cover and print using the straight paper path.
Short paper
Open the Back Cover and then press Go.
Step Cause Remedy
1 Registration rear actuator
caught on some position
Re-assemble the registration rear
actuator.
2 Registration rear sensor failure Replace the registration front/rear sensor
PCB ASSY.
3 Main PCB failure Replace the main PCB ASSY.
Small paper
Open the Back Cover and then press Go.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
