Brother HL-S7000DN - 2.3 Deletion of User Setting Data; 2.4 Changing Return Value of USB No.; Adjusting of Left-end Print Start Position on Second Side i...

5-58
Confidential
2.3 Deletion of User Setting Data
User setting data can be deleted at a time with the following procedure.
<Operating procedure>
(1) While the machine is in the ready state, press the or button to display "Reset Menu"
on the LCD and press the OK button.
(2) Press the Cancel and buttons at the same time. "Setting Reset/Reset Printer/1.Reset
2.Exit" is displayed on the LCD.
(3) When you press the 1 button, "Reboot OK?/1. Yes 2. No" is displayed on the LCD.
When you press the 1 button again, "Please wait" is displayed on the LCD, the user
setting data is deleted, and the machine returns to the ready state.
2.4 Changing Return Value of USB No./
Adjusting of Left-end Print Start Position on Second
Side in 2-sided Printing
(This is the same function as the LCD model maintenance mode function
"1.4.15 Not-disclosed-to-users functions (Function code 45)".)
 Changing return value of USB No.
When the OS of the computer is Windows Vista
®
, and the computer is connected to a
device through USB 2.0 full speed, the OS might fail to get the serial No. of the USB
device depending on the computer and USB device. When the OS fails to get the serial
No., the return value may continue to increase every time the device is connected to the
computer. To avoid this problem, you can fix the return value of the USB No. to "0" by
setting "USBNo. = ON".
"*" is displayed at the end of the currently specified function in the LCD display
<Operating procedure>
(1) While the machine is in the ready state, press the Go and buttons at the same time.
"USBNo." is displayed on the LCD.
(2) Press the OK button. "USBNo.=ON" is displayed on the LCD.
(3) When you press the or button to fix the return value of the serial number to "0" or
not to fix it to "0", display "USBNo. = ON" or "USBNo. = OFF", respectively.
(4) Press the OK button. "Accepted" is displayed on the LCD, and the machine returns to the
ready state.
(5) Turn the power OFF.
LCD Description
USBNo.=ON Returns the serial No. of the device. (default)
USBNo.=OFF Returns "0".
Note:
The new setting of this function becomes valid by turning OFF and ON the power of the
machine after the setting.