Brother HL-T4000DW - Page 338

Level 1 Level 2 Level 3 Descriptions
Sleep Mode
- - Select how long the machine must be idle before it
goes into Sleep Mode.
Auto Power Off
- - Select how long the machine must wait before it
automatically turns itself off after entering Sleep
Mode.
When set to Off, the machine will not power off
automatically.
[Network]
[Settings] > [All Settings] > [Network]
Level 1
Level 2 Level 3 Level 4 Descriptions
Wired LAN TCP/IP BOOT Method
- Select the Boot method that best suits your
needs.
IP Address
- Enter the IP address.
Subnet Mask
- Enter the Subnet mask.
Gateway
- Enter the Gateway address.
Node Name
- Enter the Node name.
WINS
Configuration
- Select the WINS configuration mode.
WINS Server
- Specify the IP address of the primary or
secondary WINS server.
DNS Server
- Specify the IP address of the primary or
secondary DNS server.
APIPA
- Set the machine to allocate the IP address
from the link-local address range
automatically.
IPv6
- Turn the IPv6 protocol on or off. For more
detailed information, go to your model's
FAQs & Troubleshooting page on the
Brother support website at
support.brother.com.
Ethernet
- - Select the Ethernet link mode.
Wired Status
- - View the current wired status.
MAC Address
- - View the machine's MAC address.
WLAN TCP/IP BOOT Method
- Select the Boot method that best suits your
needs.
IP Address
- Enter the IP address.
Subnet Mask
- Enter the Subnet mask.
Gateway
- Enter the Gateway address.
Node Name
- Enter the Node name.
WINS
Configuration
- Select the WINS configuration mode.
WINS Server
- Specify the IP address of the primary or
secondary WINS server.
DNS Server
- Specify the IP address of the primary or
secondary DNS server.
333