3. DISASSEMBLY
３-２. Work clamp arm mechanism (KE-430B, 430C, 431B, 431C)
1. Set screw
2. Needle
3. Needle bar thread guide
4. Bolts [2 pcs]
5. Work clamp arm assy
6. Work clamp felt
7. Screws [2 pcs]
8. Feed plate
9. Rubber cap
10. Set screw [Loosen]
11. Tack width feed shaft
12. Rod end
13. Screws [8 pcs]
14. Feed bracket guide plate
15. Feed bracket assy
16. Flat screws [2 pcs]
Be careful not to drop these three bearing balls
when removing the work clamp arm assembly.
Be careful not to drop these two bearing balls
when removing the feed bracket assembly.
Remove the feed bracket guide
plate and the feed bracket
assembly together as a single unit.
3271Q
17. S
crews [2 pcs]
3272
Q
18. Ne
edle plate
KE-430B, 430C series
24
To Next Page
Loading...
